For FARGO Pro and Pro-L ID Card Printers User's Manual

Chapter 5: Interpreting LCD DisplayMessagesWhile encoding SmartGuard or SmartShield information onto aSmartGuard Access Card, it is important to refer to theprinterÕs LCD Display to confirm whether or not theinformation was successfully encoded. The following tableoffers a complete list of SmartGuard and SmartShield relatedLCD Display messages along with an explanation of the causeof each message. If the message is communicating an error orrequires an action, the table also offers a solution explainingwhat should be done. For a complete list of all other LCDDisplay messages, please refer to your printerÕs UserÕs Manual.Message Cause SolutionDelete Key Data? Appears when you are Press the printerÕsRESUME=Delete trying to delete a Pause/Resume button toSmartGuard Access Card. complete the deletionprocess. If you decide notto delete the card, press theprinterÕs On/Cancelbutton.Insert New Key Appears when you are Remove the valid accessRESUME=Duplicate trying to duplicate a card being duplicated andSmartGuard Access Card. insert a blank access card.Then, press the printerÕsPause/Resume button tocomplete the duplicationprocess. If you decide notto duplicate the card, pressthe printerÕs On/Cancelbutton.Invalid Key Card The SmartGuard Access Insert a valid SmartGuardCard is invalid or is Access Card or reinsertinserted backwards or the card properly with theup-side-down.chip end down and facingyou as shown on page 4.Invalid Password You have entered an Re-enter the correctinvalid SmartGuard password using any ofpassword.the standard keyboardcharacters.Interpreting LCD Display Messages 31