LPS Instruction Manual - HygroMatik

7.2 Vortex wall module assemblyThe vortex module wall provides firstly the air turbulence andsecondly it holds the atomiser nozzles and water distributor.The vortex module wall is supplied as specified (please note thenumber of vortex modules in width and height), assembled in theaccompanying nozzle assembly data sheet:» The Vortex modules are slotted together piece bypiece, starting at the bottom right1The bottom right vortex module must be so positioned that theright hand and lower side is flat surface up while the other twosides show the guide bars (1).7.3 Assembling the vortex module wallTwo guide rails are required for assembly of the vortex modulewall.We recommend to have an air gap sideways between the vortexmodule wall and the housing wall as it generates a laminar airflow and prevents moisture build-up on the walls.7.3.1 Guide rails for the vortex module wall:In order to position the vortex module wall in the humidificationchamber guide rails are required. The guide rails are fixed to theceiling and the floor of the humidification chamber.The guide rails must be installed in a way that makes it possibleto either pull out of or lift up the vortex module wall and stagnantwater is prevented.Ensure that after installation the floor of the humidification chamberis leackage-free.Page 22