LPS Instruction Manual - HygroMatik

More documents

Recommendations

Info

12. CommissioningNote: The LPS nozzle system may only be operated by qualifiedpersonnel.Turning the LPS nozzle system offNote: Before the LPS nozzle system is put into operation, itmust be clear how to switch the system off.» Switch off Nozzle system using control switch (Pos.0).» Shut off water supply shut-off valve.Check all cable connections» Check all cable connections for tightness.Activating the LPS nozzle system» Operate main switch.» Set manometer to „open“» Open up water shut-off valve» Switch on unit using control switch (Pos.I).» Set commissioning control to permanent demandsteam production.The following functions begin:A self-test.When humidity is demanded, the pump vane is operated anddirects the water at a pressure of up to 16 bar to the nozzle.The water is atomized at the nozzle. All nozzles should not dripand show an even spray pattern.Further tests: All electrically-powered functions must function.» Observe LPS nozzle system and let it run for 15-30minutes. The air conditioning duct fan should be in operationso that the moisture produced can be blownaway. Should any leakages be evident then turn theLPS nozzle system off.» Eliminate the leaks:Attention, voltage! Please observe all safety instructions whileworking on live components.Page 48
13. MaintenanceThe HygroMatik nozzle system LPS is maintenance-friendly.However, operational faults which can be traced back to inadequateor improper maintenance may occur.Regular maintenance of the HygroMatik nozzle system LPS isindispensable for ensuring long service life.Caution: For maintenance work please bear in mind that:• the system must be serviced by qualified appointed staffonly;• safety instructions must be followed;• the system must be taken out of operation and secured toprevent it from being switched (take the plug out of thesocket) on before maintenance work is performed;• after maintenance work has been completed the devicemust be inspected by qualified staff to determine whether itis safe to operate.13.1 Maintenance activitiesFor the system to operate without any problems the followingchecks and maintenance tasks must be carried out regularly:1 x per month:» Check housing for contamination and clean if necessary.» Carry out a visual inspection of droplet separators andclean if necessary.» Check the water filter cartridge upstream of the pumpfor contamination and replace if necessary; flush themains water system if necessary.» Check the resulting spray cone of the nozzles andclean or change nozzles if necessary.1 x per year (or after 2500 h)» Nozzles should be checked as part of annual maintenanceand cleaned if necessary (see "Cleaning nozzle).If required, the nozzles to be replaced.» Water filter cartridge change» Visual inspection of the vortex module wall, if necessaryclean.» Check shutdown function, such as a "Max-Hygrostat".Page 49
Page 1 and 2: Operating manualLPSHumidifies and C
Page 3 and 4: 1. Introduction ...................
Page 5 and 6: 1. IntroductionDear Customer,Thank
Page 7 and 8: Exemptions of usage:The HygroMatik
Page 9 and 10: Supervise children in order to ensu
Page 11 and 12: 4. Function and design4.1 Functioni
Page 13 and 14: 4.2.3 Vortex modulesThe vortex modu
Page 15 and 16: 4.2.5 Droplet separators (optional)
Page 17 and 18: 5. Connnections5.1 WaterConnection:
Page 19 and 20: 6. Interfaces to the HygroMatik noz
Page 21 and 22: 7. Mechanical assemblyCaution: The
Page 23 and 24: 7.3.2 Examplary design of guide rai
Page 25 and 26: 7.4 Installation of the nozzles, di
Page 27 and 28: 7.4.3 PipingManifold - Nozzles» Th
Page 29 and 30: Assembly of the hose guide» Drill
Page 31 and 32: » Check by gently pulling the tube
Page 33 and 34: Dimensions of guide rails for dropl
Page 35 and 36: 7.6 Pump station wall mountingThe i
Page 37 and 38: 8. Dimensions - Pump StationView fr
Page 39 and 40: Note: There must be a stopcock and
Page 41 and 42: 9.4 Water QualityConductivity:5-20
Page 43 and 44: 11. Electrical connectionCaution: V
Page 45 and 46: 11.3 Circuit diagramUVWNL3215.09.20
Page 47: 11.4 Inspecting the electrical inst
Page 51 and 52: 1. Set the main switch on the contr
Page 53 and 54: 13.1.5 Cleaning the humidification
Page 55 and 56: 14.1.1 Full load and part loadThe H
Page 57 and 58: Functional description of the displ
Page 59 and 60: 14.2.2.1 Reading level:The followin
Page 61 and 62: 14.2.3 Overview of error reportsFau
Page 63 and 64: 15. EC declaration of conformityPag
Page 65 and 66: Artikel-Nr. Article no. Vortex-wall
Page 67 and 68: 18. Technical SpecificationsLPS 45
Page 69 and 70: 43Page 69

LPS Instruction Manual - HygroMatik

Create successful ePaper yourself

Delete template?

Save as template?