B-SX600 SERIES - Finn-ID

More documents

Recommendations

Info

2. LCD MESSAGE EO13-330062. LCD MESSAGE2. LCD MESSAGEMessages below which indicate the printer status and errors are displayed on the LCD.MessagesPrinter StatusReadyThe printer is ready to print.Pause ##### (Number of labels issued.) The printer is in a pause state.Pause Head unit lifted.The printer is in a pause state, and the Upper Unit is lifted.Pause Front cover open.The printer is in a pause state, and the Front Cover isopened.Pause Side cover open.The printer is in a pause state, and the Side Cover isopened.PrintingPrinting is being performed.Take off the label.When the model with the Peel-off Unit is used, a peeledlabel is still not removed from the media outlet.Low Power ModeThe printer is in Low Power Mode.Paper feed errorA media jam has occurred.The loaded media has not been fed properly.End of PaperThe printer has run out of the media.Paper info conflictThe media calibration has failed.No ribbon requiredThermal paper is selected, but a ribbon is loaded.Ribbon error Set a new ribbon.The printer has run out of the ribbon.Ribbon error Reset ribbon.The ribbon has torn apart.Ribbon error Reset head unit.The rotation of the ribbon shaft has not been detected.Peeling failedPeeling has failed.Cut failedThe media has not been cut correctly.Page Info. ErrorPage information command errorAction Info.ErrorOperation information command errorImage Info.ErrorImage information command errorUnable to respondNo response can be returned to your host computer.Overheated thermal headThe thermal head is overheated.Note: Regarding the error messages and their descriptions, please refer to section 12.5 of Owner 'sManual.2-1
2. LCD MESSAGE EO13-330062.1 DISPLAY WHEN “Ready” IS SHOWN2.1 DISPLAY WHEN “Ready” IS SHOWN• When the printer is in a normal stateReadyNo. 00000Power Ready Error DataThe printer status is shown.The number of labels printed is shown.The cumulative number of printed labels is shown after theprinter is turned on.It is cleared when the printer is turned off.(It can also be cleared from the Menu.)• Display in the event of a warningReadyBad thermal head.No. 00000Power Ready Error DataA warning message appears.(e.g. “Bad thermal head”, “Paper near end”)A buzzer sounds in the event of a warning, and the Error LEDflashes.(The buzzer stops sounding either after a lapse of a buzzersounding time specified on the Menu or by pressing any of thebuttons on the Operation Panel.)2-2
Page 1 and 2: TOSHIBA Barcode PrinterB-SX600 SERI
Page 3: 1. KEY OPERATION PROCEDURE EO13-330
Page 7 and 8: 2. LCD MESSAGE EO13-330062.3 DISPLA
Page 9 and 10: 3. PRINTER OPERATION USING THE OPER
Page 11 and 12: 3. Printer Operation using the Oper
Page 17 and 18: 3. Printer Operation using the Oper

B-SX600 SERIES - Finn-ID

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?