Retriever IV Fraction Collector User Manual - Isco

More documents

Recommendations

Info

Retriever IV Fraction CollectorSection 5 MaintenancePin #Valve JackTable 5-2 Rear Panel Connector Pin DescriptionsFunctionDirection ofSignalDescription1 Valve Output Open collector to switch valve2 + 12 VDC — —Pump Plug1 N.O. — normally open contact2 N.C. — normally closed contact3 common — armature contactCount Jack1 count input CMOS of TTL Logic “0”, or contact closure, ordrop counter photocell2 +12 V supply output resistance plus supply for the photocell3 +12 V supply output resistance plus supply for a switch4 common — —5 pump stop output open collector provides a pump stop signalbetween tube6 +5 V supply output resistance plus supply for a lampMonitor Jack1 +12 V — —2 advance (tube change) input contact closure or open collector referenced tocommon to change tube, greater than 22 millisecondsin duration4 rack event mark output open collector provides an event mark betweenracks5 tube event mark output open collector provides an event mark betweentubes6 pause input contact closure or open collector referenced tocommon, to control the running of the fractioncollector8 earth — —9 common — —11 motor stop input open collector or contact closure referenced tocommon will keep the motor from running12 valve output open collector to switch valve13 pause count input contact closure or open collector referenced tocommon to stop any count input14 end of run output open collector, provides a signal when collectionis done15 14 VAC — —5-12
Retriever IV Fraction CollectorSection 5 Maintenance5.9 Service Department If you have a problem with the instrument or need parts information,contact the Teledyne lsco Service Department. If youwrite, please include all information that may be helpful insolving your problem. Contact information can be found at thebeginning of this manual.We strongly suggest that you contact the Service Departmentbefore deciding to return the unit for factory repair. Often aproblem can be solved in the field with just a call or letter to theService Department.5.10 How to Ship Returns Be sure all parts and hardware are back in place before packing.Wrap the unit in heavy paper or put it in a plastic bag. If theoriginal carton is not available put the wrapped unit in a strongcardboard box at least six inches longer in each basic dimensionthan the unit. Fill the box equally around the unit with resilientpacking material (shredded paper, bubble pack, expanded foamchunks, etc.). Seal it with strapping tape or gummed cloth tape.It is very important that the shipment be well packaged and fullyinsured. Damage claims must be settled between you and thecarrier. This can delay repair and return of the unit to you.5.11 Purchasing Parts Only the parts listed in the replacement parts list of this manualare stocked for immediate delivery by Teledyne Isco. Virtually allother parts are also available, but there may be some delay inshipping them because they are not normally stocked.When ordering replacement parts, please supply the followinginformation:1. Series number of the unit2. Item number3. Part number5-13
Page 1: Retriever IVInstruction ManualPart
Page 5 and 6: Retriever IV Fraction CollectorSafe
Page 7 and 8: Retriever IV Fraction CollectorSafe
Page 9 and 10: Retriever IV Fraction CollectorTabl
Page 11 and 12: Retriever IV Fraction CollectorSect
Page 17: Retriever IV Fraction CollectorSect
Page 51: Retriever IV Fraction CollectorSect
Page 55 and 56: Retriever IV Fraction CollectorAppe
Page 67: NOTICEDisregard the following “De
Page 71: Teledyne Isco One YearLimited Facto

Retriever IV Fraction Collector User Manual - Isco

Create successful ePaper yourself

Delete template?

Save as template?