968 Spectrophotometer Operation Manual ***discontinued ... - X-Rite

5.3 RS232 I/O ParametersYour instrument comes equipped with a serial port that allows data to betransmitted/received to/from an external device. Listed below are the available I/Oparameters.• "RCI ON/OFF" (Remote Control Interface) - enables or disables the abilityto externally control the 948/968 via the I/O port.• "BAUD" - determines the input/output rate (characters per second) of theI/O port. Available outputs are: 300, 600, 1200, 2400, 4800, and 9600.• "CR WITH LF/CR WITH NO LF" (Carriage Return with LineFeed/Carriage Return with no Line Feed) - varies the delimiter at the end ofeach line of data. When set to CR WITH NO LINE FEED, just a CarriageReturn is sent at the end of a line of data. When set to CR WITH LF, aCarriage Return and then a Line Feed are sent at the end of a line of data.• "HANDSHAKE" is used for data transmission. Handshake may be set toHANDSHAKE OFF (ASCII = 13H), PIN 5 CTS (Clear to Send), PIN 5BUSY, or XON/XOFF ENABLED (ASCII = 11H). Handshake shouldnormally be set to OFF when it is not being used.1) Press both [FUNCTION] and [ILLUM] atthe same time.> To exit I/O Setup: Press[FUNCTION] and [ILLUM] at thesame time and the unit will returnback to normal operation.C 2X Y ZX 4 . 1 2Y 2 . 8 7 Z 2 . 4 1FUNCTION ILLUM DIFCALPRESS AT SAME TIME2) Select "NO", press [FUNCTION] threetimes.NOCALIBRATE ?YESPRESSTHREEFUNCTION ILLUM DIFCALTIMES39