User Manual Micro-Cal™ Model 869 - Dipl.ing. Houm AS

EDIT DEFAULTS PAGEDisplay trend graph on UUT warm-up box will make a graph appearwhen the DoTest Button is pressed on test page.The graph will show UUToutput vs. time to allow the operator to seeif the UUT has a warm-up drift, and output has been stabilized. (Thisfeature is not likely to be required if the units to be tested are normallyconnected to a power supply.)Display test results in graph will make a graph appear at the end of theautomated test. Graph will show the UUT output error seen during testvs. applied pressure.Turn on excitation warning setting will make a dialog box appear onscreen anytime the excitation is about to be changed to a higher level.(This is used to help prevent damage to unit. If all units to be tested canaccept 24VDC excitation, feature will not likely be required.)Turn on miswire warning will make a dialog box pop up when itappears the UUT wiring or plumbing has been reversed, or if the UUTpressure range appears to be set incorrectly.Turn on test results save warning will make a dialog box appear at anypoint where unsaved test results could be deleted.Manual step-through test will stop a test in progress at each pressurepoint and require user to press ‘OK’ on pop-up dialog.Add extra digit to pressure display increases pressure resolutionshown on real-time page. Adds one digit to the end.Restore Factory Default Settings resets default settings to factoryprogramming.Edit Default AUTO-DETECT Settings opens a page to access settingsfor AUTO-DETECT units (269, RPM). (See Diagram 19, pg. 29)Display Trend Graph on UUT Warm-upDisplay Test ResultsExcitation Setting WarningMiswire WarningTest Results Save WarningManual Step-Through TestExtra Digit ResolutionRestore Factory DefaultsOpens AUTO-DETECT Default Settings PageDiagram 1828