- Page 1 and 2:
READ ALL INSTRUCTIONS COMPLETELY AN
- Page 3 and 4:
CONGRATULATIONSYou have purchased t
- Page 5 and 6:
DISCLAIMER OF WARRANTYPurchasers re
- Page 7 and 8:
Installing SuspensionNote: The phot
- Page 9 and 10:
The balljoint is then screwed into
- Page 11 and 12:
Thread the balljoint in as far as p
- Page 13 and 14:
Next, chase the threads in the lowe
- Page 15 and 16:
If you have to remove the lower A-a
- Page 17 and 18:
Next, install the shock simulator a
- Page 20:
With the cotter pin installed, use
- Page 26 and 27:
Install the tie rod end in the stee
- Page 28 and 29:
First, check and record the camber
- Page 30 and 31:
Next, set the bar level and tighten
- Page 32 and 33:
Next, you can final assemble the ti
- Page 34 and 35:
The caps are held in place with the
- Page 36 and 37:
With both bushings on the bar, brin
- Page 38 and 39:
Next, slide the link eyebolt onto t
- Page 41 and 42:
Screw the spring seat adjuster onto
- Page 43 and 44:
Install the lower shock spud first.
- Page 45 and 46:
Add a drop of Loctite to the thread
- Page 47 and 48:
Pack the outer wheel bearing as you
- Page 49 and 50:
Next, install the Wilwood brake cal
- Page 51 and 52:
Use a 3/8” wrench to tighten the
- Page 53 and 54: Move the spindle to full right lock
- Page 55 and 56: Insert one urethane bushing into ea
- Page 57 and 58: These optional stainless steel "spu
- Page 59 and 60: Installing Manual Transmission,Clut
- Page 61 and 62: Item 5916-F20-03 Turbo 400, 200-4R,
- Page 63 and 64: After you remove the engine, place
- Page 65 and 66: Use vise grip pliers and an end wre
- Page 67 and 68: Disconnect the clamps that attach t
- Page 69 and 70: Remove the bolts that attach the en
- Page 71 and 72: You need three people; one to opera
- Page 73 and 74: Lower the clip to the ground and pu
- Page 75 and 76: This is the correct orientation of
- Page 77 and 78: Place the top part of the mid and r
- Page 79 and 80: Install the lower half of the rear
- Page 81 and 82: Measure from the lip on the rocker
- Page 83 and 84: Attach the stock hook rod to the pa
- Page 85 and 86: Install two 1/2” self-locking set
- Page 87 and 88: Slide the splined end of the u-join
- Page 89 and 90: This is a photo of the completed in
- Page 91 and 92: Drill a 1/8” hole centered in the
- Page 93 and 94: Drill the remaining rivet holes sta
- Page 95 and 96: Installing HeadersSpecial Note: We
- Page 97 and 98: Installing SubframeConnectorsThe su
- Page 99 and 100: Once you have all the bolts removed
- Page 101 and 102: The spring clips can be just as tri
- Page 103: Slide a 3/8 inch flat washer over t