Complete (13 MB) - Chris Alston's Chassisworks
Complete (13 MB) - Chris Alston's Chassisworks
Complete (13 MB) - Chris Alston's Chassisworks
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
When installing the lower A-arm pivot studs,be careful not to damage the threads. Tapthe pivot stud into place with your hand.If the hand method does not work, you canuse a plastic-tipped hammer to gently installthe pivot stud. It is best to move the pivotstud a small amount at a time until thethreads make contact.Do not put grease on the pivot bushings theyare self-lubricating.Once the pivot studs are in place, use anAllen T-wrench to tighten them. The pivotstuds should go in easily and should betightened until they are fully seated. This willgive the bushings the proper amount ofcrush, and allow the lower A-arm to movewith a small amount of resistance.917703 Page <strong>13</strong>