S5600 Installation Instructions - Efco

Series 5600 Outside Glazed Installation InstructionsSection III: Typical Anchorage MethodsSTEP #5 INSTALL FRAME COMPONENTSRepeating steps 3 and 4, set each successive frame into the opening snapping theverticals and fillers at each frame until all frames are installed up to the lastframe at the opposite jamb. Check frequently to ensure the installed framing is inproper position with regard to established benchmarks.See step 6, page 12for special sealantnote at horizontals.* NOTE: On long runs, check overall frame dimensions at every fifth opening to avoiddimensional build-up. The commercial cut length tolerance is +/- 1/16”. It is criticalto check every fifth unit for location relative to established benchmarks.EFCO CORPORATION 6/2012 PART NO. YS56 Page 11 of 54