S5600 Installation Instructions - Efco

More documents

Recommendations

Info

Series 5600 Outside Glazed Installation InstructionsSection III: Typical Anchorage MethodsSTEP #2 INSTALL FRAME COMPONENTSA.)B.)C.)D.)Apply backer rod and sealant at the perimeter channel anchor.Apply a bed of sealant along the back of the channel for the full heightof the frame.Seal each end of the channel to the condition. (See inset below).Set the first assembled frame into the opening in a bed of sealant.Apply temporary retainers at the frame perimeter. (See ‘Tool thesealant’ with a trowel as shown.)Continuous sealant bedShim as requiredPerimeter channel anchorBacker rod and sealantAnchor bolts as req’d.(Cap seal)Tool sealantSeal top and bottom of thechannel to the opening.Set frame in sealant.Jamb ConditionEFCO CORPORATION 6/2012 PART NO. YS56 Page 8 of 54
Series 5600 Outside Glazed Installation InstructionsSection III: Typical Anchorage MethodsSTEP #3 INSTALL FRAME COMPONENTSA.)B.)C.)Insert ‘F’ anchors into each end of the intermediate vertical, and set framesinto openings.Use temporary retainers at the jamb conditions to hold the frame inposition. Space the temporary retainers 18” to 24” on the jamb.Using dead load shims beneath each vertical mullion to level the frame,make all necessary adjustments to properly locate the frame to establishbenchmarks.‘F’ anchorDead load shimsTemporary retainer withisolator and screwNote: Temporary retainers are available from EFCO by request only and are notincluded in the cost of the materials for the project.Note: Refer to approved shop drawings for shimming guidelines.EFCO CORPORATION 6/2012 PART NO. YS56 Page 9 of 54
Page 4: Series 5600 Outside Glazed Installa
Page 11 and 12: Series 5600 Outside Glazed Installa

S5600 Installation Instructions - Efco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?