S5600 Installation Instructions - Efco

More documents

Recommendations

Info

Series 5600 Outside Glazed Installation InstructionsSection V: Alternate Anchorage Method (PunchedOpenings)STEP #2 Install Frame ComponentsInstall perimeter channel anchor to the head and sill with appropriate shims andanchor bolts. The channel must be set to proper benchmarks for final position of thewall. The ends of the channels should be mitered for continuity, and should abut andseal to the ends of the anchor channels at the jambs. See inset at step #3.Refer to approved shop drawings for job specific conditions, anchor bolt sizes, andlocations. Install assemblies according to approved shop drawings.Anchor bolts as required.Mitered ends atchannel anchorsPerimeter channelanchor.Shims as required.Head & Sill ConditionEFCO CORPORATION 6/2012 PART NO. YS56 Page 22 of 54
Series 5600 Outside Glazed Installation InstructionsSection V: Alternate Anchorage Method (PunchedOpenings)STEP #3 Install Frame ComponentsA.)B.)C.)D.)E.)Apply backer rod and sealant at the perimeter channel anchor.Seal the mitered ends of the channel as shown. (See inset below.)Apply a bed of sealant along the back of the channel on all four sides of theopening.Set the first group of frames into the opening in the bead of sealant. Theframes must be set immediately after the sealant is applied for properinstallation.Apply temporary retainers at the frame perimeter. Tool the sealant with atrowel as shown.Continuous sealant bedPerimeter channel anchorShims as required.Anchor bolts asrequired. (Cap seal)Backer rodand sealantTool sealant.Seal the miteredcorners togetherthoroughly, and toolsealant into the joint.Set frame in sealant.EFCO CORPORATION 6/2012 PART NO. YS56 Page 23 of 54
Page 4: Series 5600 Outside Glazed Installa
Page 7 and 8: Series 5600 Outside Glazed Installa

S5600 Installation Instructions - Efco

Create successful ePaper yourself

Delete template?

Save as template?