S5600 Installation Instructions - Efco

More documents

Recommendations

Info

Series 5600 Outside Glazed Installation InstructionsSection II: Frame Unit Assembly & Frame SealingApply a generous bead ofsealant to the ends of thehorizontal mullion aminimum of 1” back fromthe face of the horizontalglazing pocket.Frame gaskets may be used as an alternate method for frame sealing and are NOT BY EFCO.Use .062 X 3” PVC foam tape with adhesive on one side. Apply the gasket to the end of thehorizontals, assemble, and trim the excess gasket from around the horizontal.NOTE: Gasket material used must be compatible with the sealants used for the installation.AFTER EACH FRAME UNIT ASSEMBLY IS COMPLETE, WIPE OFFALL EXCESS SEALANT AND ALLOW THE FRAME UNIT TO CURE.EFCO CORPORATION 6/2012 PART NO. YS56 Page 6 of 54
Series 5600 Outside Glazed Installation InstructionsSection III: Typical Anchorage MethodsSTEP #1 INSTALL FRAME COMPONENTSInstall perimeter channel anchors to the jamb conditions with appropriate shims andanchor bolts. The channel must be set to proper benchmarks for the final position of thewall. The top and bottom of the channels should align with the top of the head andbottom of the sill frame dimensions. Refer to the approved shop drawings for jobspecific conditions, anchor bolt sizes and locations. Install assemblies according toapproved shop drawings.Shim as requiredPerimeter channel anchorAnchor bolts as requiredJamb ConditionEFCO CORPORATION 6/2012 PART NO. YS56 Page 7 of 54
Page 4: Series 5600 Outside Glazed Installa
Page 9 and 10: Series 5600 Outside Glazed Installa

S5600 Installation Instructions - Efco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?