Windchill System Administrator's Guide

Editing the wt.properties File
Master and Replica Properties
Setting properties in the wt.properties file is an essential activity in configuring
Content Replication. If you are not setting properties through a graphical user
interface or in a mapping file, you add or edit properties with the xconfmanager
utility, which is discussed elsewhere in this guide.
The following list describes the properties that are most relevant to Content
Replication, categorized by their area of influence. All of these properties are
present in all wt.properties files present on master and replica servers, but many of
the properties are relevant only to master site or replica site servers. Some of the
properties control the placement or behavior of log files, which can be important
in troubleshooting. If you have not planned the details of the Content Replication
sites, you may be unable to provide correct values for some properties until you
have completed the setup procedures.
The following table shows the properties that are set on master sites, replica sites,
and both.
Property Master Replica
wt.fv.master.verboseProperties X
wt.fv.master.verbose X
wt.fv.master.log.enabled X
wt.fv.master.log.append X
wt.fv.master.log.filename X
wt.fv.master.replicateQuerySize X
wt.fv.replica.verbose X
wt.fv.replica.log.enabled X
wt.fv.replica.log.append X
wt.fv.replica.log.filename X
wt.fv.replicationFileSizeThreshold X
Note: The wt.fv.replicationFileSizeThreshold may not appear in the file, but it is
nonetheless existing and effective. For an explanation of this property, see
Content Replication and Windchill Visualization Service on page 4-19.
Administering Content Replication 4-17