Kingfisher PLUS+

More documents

Recommendations

Info

3. Power Supply Cards AC Input Card, Regulated (PSO-ACR) - Non Hazardous Locations Only FEATURES AC or DC Input Supply Auxiliary DC Output Monitoring - supply voltage and current Low Voltage Shutdown Backup Battery Charging This power supply card accepts AC / DC mains input (or DC battery input) and outputs DC voltages used to power the G30 and external equipment such as a radio. It also provides monitoring and protection of the power supply circuitry. WARNING: If a PSO-ACR power supply card is used, the G30 RTU is suitable for use in nonhazardous locations only. G30 Hardware Manual 1.3 www.rtunet.com/support Page 10
PSO-ACR Specifications Input Supply Input Protection Output Power Backup Battery Auxiliary Output Isolation Input Supply Fuse Connectors Environment Output Noise Monitoring EMC & Safety Compliance Accessories (supplied with card) Power Consumption 90-260 VAC, 50-60 Hz 96-340 VDC Note: can also be powered using 11 to 14.5 VDC when powered from the backup battery terminals. Under Voltage (< 80 VAC) and Over Voltage (> 400VAC) on the mains input Reverse Voltage and Over Voltage (> 18 VDC) on the battery input Regulated 35W Total Nominal Voltage Battery Fuse Deep Discharge Protection Intelligent Battery Charging 13.8 VDC. Boost charges battery using up to 14.2 VDC @ 7 A max. 6A @ 20 C polyfuse (auto-resettable). Provides short circuit and overload protection. Yes. RTU shuts down at < 10.5 V Restarts at > 11.5 V Yes. Temperature compensated. 12 VDC @ 2.5 A max. Protected against short circuit and overload Controllable using logic (can switch OFF and ON) Maximum working voltage: 300 V RMS Dielectric Strength: 2600 VAC or 3000 VDC for 1 minute 1.6 A IEC 60320-C14 Mains Power Inlet (standard IEC computer power socket) 6-way pluggable terminal block for Auxiliary output, external Temperature Sensor and Battery Operating Temperature Operating Humidity -40 to 70 o C 500 mV peak-to-peak over 10 Hz to 10 MHz. Item Power Supply Voltage Power Supply Current Power Supply Temperature External Temperature (from ext. temp. sensor) Battery Current Battery present AC Present C-tick 5-95% RH @ 0 to 40 C non-condensing Accuracy + 0.2 V + 100 mA + 3 °C + 3 °C + 100 mA 2.5m right-angle IEC 60320-C13 mains power inlet lead (with no mains plug fitted) External Temperature Sensor 6-way Terminal Block plug 1W maximum (consumed by power supply card) G30 Hardware Manual 1.3 www.rtunet.com/support Page 11
Page 1 and 2: Kingfisher PLUS+ G30 Hardware Manua
Page 3 and 4: SAFETY WARNINGS CAUTION Installatio
Page 5 and 6: 1. G30 Standalone RTU FEATURES C-ti
Page 7 and 8: Port 1 Ethernet Pinout RJ45 Pin Eth
Page 9: Wiring Diagram - RS422 4-Wire The M
Page 13 and 14: DC Input Card, Unregulated (PSO-DCU
Page 15 and 16: 4. IO Daughter Cards IO Daughter Ca
Page 17 and 18: MX2 / MX3 Digital Inputs Inputs per
Page 19 and 20: MX2 / MX3 Analog Inputs Inputs per
Page 21 and 22: IO Daughter Card - MX4: 16DI, 16DO
Page 23 and 24: MX4 Digital Inputs Inputs per card
Page 25 and 26: MX4 Wiring Diagram View ing Front O
Page 27 and 28: G30 Serial Port Converter Converts
Page 29 and 30: MaxStream External Spread Spectrum
Page 31 and 32: 7. Glossary AI, AO, DI, DO Analog I
Page 33 and 34: 5. Connect short cable to MX card.
Page 35 and 36: 15. Install front case, taking care

Kingfisher PLUS+

Create successful ePaper yourself

Delete template?

Save as template?