Kingfisher PLUS+

MX2 / MX3 Digital Outputs
Outputs per card 8
Rated Switched Voltage 12 to 24 VDC
Output Type
Transistor, Open Collector, Current Sinking
Output Grouping 2 groups: outputs 1 to 4 and outputs 5 to 8
Each group has a separate common
Maximum Switched
60 VDC
Voltage
Maximum Switched
Current
Isolation
Output Protection
Output Update Time
Failsafe
Pulse / Frequency
Generation
100 mA per channel, self limited
500 V RMS channel to logic
100 V RMS channel to channel between input groups
250 V RMS channel to field power
250 V RMS channel to other types of IO channels (DI, AI and AO)
No isolation between channels in the same group
Yes. Protected against reverse polarity and transient over voltage and current
1 ms (for all channels)
Yes. Software configurable on any channel(s). If failsafe is disabled, output
holds last state. Failsafe is triggered after 10 seconds of no communications to
the G30.
High Speed:
10 kHz maximum, 1 Hz minimum @ 50% nominal duty cycle
Configurable on channels 1 to 4
Accurate to 0.01%
Low Speed:
500 Hz maximum @ 50% nominal duty cycle
Configurable on channels 5 to 8
Accurate to 2% @ 500 Hz, 0.5% @ 100Hz, 0.1% @ 1 Hz
Configurable Pulse ON or OFF time: 1 to 16,000 ms
Note: Low Speed pulse frequencies are determined by the time it takes to generate one
pulse ie. Pulse Period = Pulse ON + Pulse OFF times. Pulse frequency (Hz) = 1000 /
Pulse Period (ms).
G30 Hardware Manual 1.3 www.rtunet.com/support Page 18