Kingfisher PLUS+
Kingfisher G30 Manual - ioSelect
Kingfisher G30 Manual - ioSelect
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PSO-ACR Wiring Diagram<br />
I<br />
ON<br />
OFF<br />
O<br />
1<br />
I/ O<br />
Tape or cable tie<br />
the temperature<br />
sensor to the<br />
negative battery<br />
terminal to enable<br />
temperature<br />
compensated<br />
battery charging.<br />
Connect black<br />
striped wire of<br />
sensor to TS-.<br />
+<br />
OPTIONAL 12VDC<br />
EXTERNAL<br />
DEVICE<br />
+ -<br />
OPTIONAL<br />
BACKUP<br />
BATTERY<br />
-<br />
+<br />
-<br />
VA+<br />
VA-<br />
TS+<br />
TS-<br />
B+<br />
B-<br />
VA+<br />
VA-<br />
TS+<br />
TS-<br />
B+<br />
B-<br />
AUX 12V<br />
OUTPUT<br />
TEMP<br />
SENSOR<br />
BATTERY<br />
IN/OUT<br />
ETHERNET<br />
USB<br />
Card is supplied with a right-angle<br />
IEC 60320-C13 mains power inlet<br />
plug and unterminated lead. Fit local<br />
mains plug where necessary.<br />
E<br />
N<br />
A<br />
POWER INPUT<br />
~<br />
90-260 VAC<br />
96-340 VDC<br />
OPTION<br />
A standard computer power cable can<br />
be used to power the card. However,<br />
the G30 door will not close.<br />
Instead of using AC mains power to power the PSO-ACR,<br />
the power supply card can be powered using a DC supply<br />
connected to the Battery terminals or to the AC input<br />
terminals as shown below.<br />
Powering the PSO-ACR Using A Low Voltage DC Supply<br />
11 to 14.5 VDC<br />
POWER<br />
SUPPLY<br />
+<br />
-<br />
B+<br />
B -<br />
Powering the PSO-ACR Using A High Voltage DC Supply<br />
96 to 340 VDC<br />
POWER<br />
SUPPLY<br />
+<br />
-<br />
A<br />
N<br />
G30 Hardware Manual 1.3 www.rtunet.com/support Page 12
Change language