Kingfisher PLUS+

More documents

Recommendations

Info

Specifications MX4 General Processor Real Time Operating System Auxiliary Output IO Connector (on card) Environment Accessories Atmel ARM7 ThreadX 24 VDC @ 250 mA (6 W) Isolated (for powering IO) Protected against continuous short circuit Isolated to 1500 V (for up to 60 seconds) Maximum capacitive load 100 µF 40 pin IDC Male Operating Temperature Operating Humidity -40 to 70 o C 5-95% RH @ 0 to 40 C non-condensing Supplied with a 1, 2 or 5 metre interface cable, 40 pin IDC female to female Supplied with a terminal interface block that is DIN rail mountable (as shown) Power Consumption 2 W / 8 W maximum with Auxiliary output OFF / ON G30 Hardware Manual 1.3 www.rtunet.com/support Page 22
MX4 Digital Inputs Inputs per card 16 Rated Input Voltage Input Type Input Grouping Input Characteristics Isolation Input Scan Time Debounce Channel Inversion Sequence Of Events Edge Counting 24 VDC (supports reverse polarity) Current Sinking 2 groups: inputs 1 to 8 and inputs 9 to 16. Each group has a separate common Impedance On-state Voltage Off-state Voltage On-state Current 4.7 k + 19.2 to 28.8 VDC + 0 to 5.0 VDC 1.4 mA minimum. Current=(Vin-1.2) / 5.7 mA Off-state Current 0.5 mA maximum 500 V RMS channel to logic 100 V RMS channel to channel between input groups 250 V RMS channel to field power 250 V RMS channel to Earth 250 V RMS channel to other types of IO channels (DO, AI and AO) No isolation between channels in the same group 1 ms (for all channels) 0 (default) to 16000 ms configurable on any channel(s). Yes. Selectable on any channel(s). Yes. Selectable on any channel(s). Triggered on change of state. Can capture up to 1000 events per second Accurate to 1 ms. Yes. Selectable on any channel(s). Can count rising or falling edges. Frequency Counting 10 kHz maximum on channels 1 and 2 500 Hz maximum on all other channels Quadrature Counting Selectable on input channels: 1&2, 3&4, 5&6, 7&8, 9&10, 11&12, 13&14, 15&16 G30 Hardware Manual 1.3 www.rtunet.com/support Page 23
Page 1 and 2: Kingfisher PLUS+ G30 Hardware Manua
Page 3 and 4: SAFETY WARNINGS CAUTION Installatio
Page 5 and 6: 1. G30 Standalone RTU FEATURES C-ti
Page 7 and 8: Port 1 Ethernet Pinout RJ45 Pin Eth
Page 9 and 10: Wiring Diagram - RS422 4-Wire The M
Page 11 and 12: PSO-ACR Specifications Input Supply
Page 13 and 14: DC Input Card, Unregulated (PSO-DCU
Page 15 and 16: 4. IO Daughter Cards IO Daughter Ca
Page 17 and 18: MX2 / MX3 Digital Inputs Inputs per
Page 19 and 20: MX2 / MX3 Analog Inputs Inputs per
Page 21: IO Daughter Card - MX4: 16DI, 16DO
Page 25 and 26: MX4 Wiring Diagram View ing Front O
Page 27 and 28: G30 Serial Port Converter Converts
Page 29 and 30: MaxStream External Spread Spectrum
Page 31 and 32: 7. Glossary AI, AO, DI, DO Analog I
Page 33 and 34: 5. Connect short cable to MX card.
Page 35 and 36: 15. Install front case, taking care

Kingfisher PLUS+

Create successful ePaper yourself

Delete template?

Save as template?