AW #131.pdf - Karatunov.net
AW #131.pdf - Karatunov.net
AW #131.pdf - Karatunov.net
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
sink holes in one piece for fastening it<br />
to the top. Drill the remaining holes for<br />
fastening both pieces to the pocket's<br />
side (D4). Fasten the top angle to the<br />
cabi<strong>net</strong> top, then install the side, spacer<br />
(D3), stop (D5) and bottom angle.<br />
Cur rHE MAT<br />
The rubber mat (Dl) comes in a 2 ft.<br />
x 3 ft. piece (see Sources, below). Use a<br />
straightedge and a utility knife to cut it to<br />
size. It will take a few passes to cut entire-<br />
ly through the n-rbber. Drill registration<br />
holes in the mat to correspond to the<br />
holes in the cabi<strong>net</strong> top. Use a utility<br />
knife to cut a recessed fingerhold on one<br />
side of the mat. A fingerhold makes it<br />
easier to pull the mat out of the pocket.<br />
Sources:<br />
RubberCal, (800) 370-91 52, www.rubbercal.com<br />
SharkTooth Rubber mat 314" x2'x 3', $30.<br />
M ight-T-Track, (888) 5 1 2-9069,<br />
www.ttrackusa.com Mini-T-Track #1 022,<br />
48" long, includes 2 knobs and 2 bolts, $18.<br />
Frc, G Sroe Daoo LRvour<br />
Fre. D TopLavour<br />
Notes<br />
{l) Add U4' edgebanding front and sides.<br />
{2) Add U4' edgebanding on front.<br />
{3) Add U4' edgebanding all around.<br />
r) GlueT-track into<br />
\-rthe slots with<br />
epoxy. Add screws<br />
to clamp theTtrack<br />
in olace.<br />
* cabi<strong>net</strong> is 33-1/2"H<br />
American Woodworker ocToBER zooz 73
Change language