Delivery Program_01_23_Englisch

Mold and Casting Resins
EP-Casting Resin System - Semi-Transparent - HP-E45GA
The Epoxy-System HP-E45GA is an unfilled, medium-viscous combination of resin and hardener with processing
time (pot life) of approx. 45 minutes.*
Usable for epoxy casting of medium thickness (up to approx. 20mm*)
HP-E45GA is free of nonylphenol and contains no active diluents!
Features and Benefits:
• Semi-transparent, low shrink-casting with tacky-free surfaces
• Good flow behaviour (medium-viscous)
• Cold-hardening, demouldable at room-temperature
• High fillable casting resin
• The results are pressure-resistant and impact-resistant (tough) moulds / components with high strength
Industrial Modelling / Hobby Modelling / Boatbuilding:
• Foundry patterns, die plates, reproduction patterns
• Building of small moulds and castings with slightly yellow colour
• Encapsulation of decorative elements
• Levelling compound
• Dielectric resin for electrical embedding up to 48 Volts
Product Properties: Resin Hardener
HP-E45GA
Colouring transparent yellowish
Mixing ratio
weight 100 60
Mixed viscosity
medium viscous
Pot life (100g at 20°C) minutes
45
Demouldable after* (at 20°C) hours
< 12
Demouldable after (at 30°C) hours
< 6
Processing temperature (optimum) °C
15 - 25
* Depends on geometry and total amount of casting. Specifications after hardening 7d at 20°C.
Technical
Data Sheet
Online Shop
90
phone: +49 (0) 5905-9459870 www.hp-textiles.com mail: info@hp-textiles.com