Engineering System - Siemens Automation and Drives Group
Engineering System - Siemens Automation and Drives Group
Engineering System - Siemens Automation and Drives Group
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4<br />
<strong>Engineering</strong> system<br />
ES software<br />
Introduction<br />
■ Overview<br />
■ Integration<br />
The functionality of the engineering system is largely covered by The ES software can be run on the ES hardware offered in this<br />
the st<strong>and</strong>ard engineering software. The following software op- catalog <strong>and</strong> has been tested with it. <strong>Siemens</strong> guarantees the<br />
tions are offered in addition for special functions:<br />
compatibility of hardware <strong>and</strong> software for system configurations<br />
for engineering systems with st<strong>and</strong>ard engineering software based on components in this catalog.<br />
SIMATIC PCS 7 V6.0 up to Service Pack 2 (already integrated<br />
in ServicePack 3 <strong>and</strong> higher): PCS 7 Option Package (S7-<br />
400H <strong>System</strong>s) for the engineering of automation systems with<br />
H architecture (H/F/FH systems)<br />
Version cross checker<br />
Import/export assistant<br />
Should you use basic hardware other than that offered in this catalog,<br />
please note the minimum requirements quoted in the chapter<br />
"ES/OS/BATCH/IT basic devices".<br />
If you configure your own SIMATIC PCS 7 engineering system<br />
using other/own hardware components, you carry full responsibility<br />
<strong>and</strong> will not receive any free support in the event of com-<br />
<strong>Engineering</strong> Process Safety for engineering of fail-safe syspatibility problems.<br />
tems, incl. SIMATIC Safety Matrix engineering tool<br />
Despite comprehensive tests it cannot be ruled out that the func-<br />
SIMATIC Route Control engineering<br />
tion of a SIMATIC PCS 7 system may be disturbed or impaired<br />
SIMATIC PDM Process Device Manager<br />
PCS 7 PID-Tuner for controller optimization<br />
S7-PLCSIM for the functional testing of CFC/SFC programs<br />
by additional non-system software, i.e. software not explicitly released<br />
for SIMATIC PCS 7.<br />
Therefore, the use of non-system software in the SIMATIC PCS 7<br />
environment is your responsibility. You have no claims for free<br />
support in the event of compatibility problems.<br />
4/4<br />
<strong>Siemens</strong> ST PCS 7 · October 2004