Installation and Operating Instruction

Operating the Controls
Set-point Information
1 Actual flame current
2 Actual supply temperature of the central heater
3 Actual return flow of the central heater
4 Actual temperature of the drinking-water
5 Water pressure
6 Type of use
7 Actual temperature of the flame pipe or TTB
8 Throughput speed of the drinking-water (Hz)
9 Current control-set-point
10 Current outside temperature (OTC-Temperature)
The set-point can be raised by 1 by quickly pressing
the 1 button (less than 1 second). When the
counter has reached its highest value, it will drop
T a s t e2
down to 0. II
Installer-mode is exited by quickly pressing the 3
button (less than 1 second). The installer mode also
has a time out function that exits the installer mode
after one minute of inactivity. This function is also
turned off if the electrical supply is interrupted.
6.3.10 Installer (+) Mode
T a s t e3
The installer (+) mode can be activated by holding
the 2 button for longer than 3 seconds. The displayed
information’s format is shown in the following
T a s t e2
display. II
Display Display Element
Parameter symbol alternates with the
index symbol. After changing the setpoint,
it will appear after 2 seconds
Segment B
Parameter value for the chosen index Segment B, C and D
Installer (+) Mode LED 2 = Blinking
- 33 -
L E D 2
L E D 3
III
L E D 2
alternating
blinking
Gebr. Bruns GmbH is not responsible for typographical errors or technical inaccuracies and reserves the right to make adjustments.
Gebr. Bruns GmbH • Hauptstraße 200 • 26683 Saterland •Tel.: + 49 (0) 44 92 / 92 46-0 • Fax: + 49 (0) 44 92 / 71 41
www.bruns-heiztechnik.de • info@bruns-heiztechnik.de