SAS 9.3 Guide to Software Updates

74 Chapter 12 / Installing a Software Update
Note: If you click Cancel, you will have installed but not configured the software
updates. You must configure the updated SAS products before you can run them.
To complete these configuration steps at a later time, see “Configure SAS Products”
in Chapter 3 of SAS Intelligence Platform: Installation and Configuration Guide.
8 If necessary, restart the SAS Metadata Server. In both Windows and UNIX
environments, the SAS Metadata Server should restart automatically.
n In Windows environments, the following message appears in the SAS
Deployment Manager if the SAS Metadata Server is not running:
A SAS Metadata Server is not currently running on the Port.
To continue the configuration steps, restart the SAS Metadata Server manually.
For more information, see “Use SAS Management Console to Stop, Pause,
Resume, or Reset the SAS Metadata Server” in Chapter 5 of SAS Intelligence
Platform: System Administration Guide.
n To restart the SAS Metadata Server manually in UNIX environments:
1 At a UNIX prompt, navigate to the directory where the SAS Metadata Server
is configured.
2 Type ./MetadataServer.sh start.