Installer manual - nibe.com
Installer manual - nibe.com
Installer manual - nibe.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
42<br />
Menu 4.9.5 - schedule blocking<br />
The <strong>com</strong>pressor and/or addition in the indoor module<br />
can be scheduled to be blocked for up to two different<br />
time periods here.<br />
If two settings conflict with each other a red exclamation<br />
mark is displayed at the end of the line.<br />
When scheduling is active the relevant blocking symbol<br />
is shown in the main menu on the symbol for the indoor<br />
module.<br />
��������� ��������<br />
���<br />
�������� �<br />
���<br />
���<br />
����<br />
��<br />
����<br />
���<br />
���<br />
���<br />
���������<br />
�������� �������� �����<br />
�������� �<br />
���� ������ ��������<br />
��������<br />
Schedule: The period to be changed is selected here.<br />
Activated: Scheduling for the selected period is activated<br />
here. Set times are not affected at deactivation.<br />
Day: Select which day or days of the week the schedule<br />
is to apply to here. To remove the scheduling for a particular<br />
day, the time for that day must be reset by setting<br />
the start time to the same as the stop time. If the line<br />
"all" is used, all days in the period are set for these times.<br />
Time period: The start and stop time for the selected<br />
day for scheduling are selected here.<br />
Blocking: The desired blocking is selected here.<br />
Blocking the <strong>com</strong>pressor.<br />
Blocking additional heat.<br />
TIP<br />
If you wish to set similar scheduling for every<br />
day of the week start by filling in “all” and then<br />
changing the desired days.<br />
Chapter 8 | Control - Menus<br />
Caution<br />
If the stop time is before the start time it means<br />
that the period extends past midnight.<br />
Scheduling always starts on the date that the<br />
start time is set for.<br />
Caution<br />
Long term blocking can cause reduced <strong>com</strong>fort<br />
and operating economy.<br />
NIBE VVM 500