Publishing Reports to the Web - Downloads - Oracle

A.4.29 DISTRIBUTE
A.4.30 DTYPE
Command Line Keywords
To specify the proxy information, edit the proxyinfo.xml file available in the
default location (ORACLE_HOME\reports\conf). Uncomment the property
entry above and specify the complete path to the proxyinfo.xml file as the
value.
For example, if your ORACLE_HOME is located in D:\9iAS, then the default
location for proxyinfo.xml can be specified as:
Table A–38 indicates which commands can use the DISTRIBUTE keyword.
Table A–38 Commands that can use DISTRIBUTE
rwclient rwrun rwbuilder rwconverter rwservlet rwcgi rwserver
yes yes no no yes yes no
Description Use DISTRIBUTE to enable or disable distributing the report output to
multiple destinations, as specified by the distribution list defined in the report
distribution definition (defined in Reports Builder at design time) or a distribution
XML file.
Syntax DISTRIBUTE={YES|NO}
Values
■ YES Distribute the report to the distribution list.
■ NO Ignore the distribution list and output the report as specified by the
DESNAME, DESTYPE, and DESFORMAT parameters. This is fundamentally a
debug mode to allow running a report set up for distribution without actually
executing the distribution.
Default NO
Usage Notes The DISTRIBUTE keyword works in close association with the
DESTINATION keyword. DISTRIBUTE must have a value of YES for the
DESTINATION keyword to take effect. If both these keywords are specified, DESTYPE,
DESNAME, and DESFORMAT are ignored if they are also specified.
Note: For more information about creating advanced
distributions, see Creating Advanced Distributions.
Table A–39 indicates which commands can use the DTYPE keyword.
Table A–39 Commands that can use DTYPE
rwclient rwrun rwbuilder rwconverter rwservlet rwcgi rwserver
no no no yes no no no
Command Line Options A-35