Untitled - Provo Craft - Cricut
Untitled - Provo Craft - Cricut
Untitled - Provo Craft - Cricut
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
If the cut was successful in staying inside the printed lines, click the<br />
select button. If the cut was outside of the printed lines, select repeat<br />
to run the test again.<br />
If the cut does not fall within the calibration test image line after running<br />
the blade calibration 3 times, you can try to tune the calibration<br />
manually using the Advanced calibration screen.<br />
note: It is strongly recommended that, prior to using the advanced<br />
calibration controls, you contact Customer Care for assistance. They<br />
will be able to give you instructions about each of the controls in this<br />
area, and direct you how to use them.<br />
To reach the Advanced screen follow these instructions:<br />
• Click the Blade button in the Calibration section of the<br />
Settings screen.<br />
• Hold the top button on the left side of the screen.<br />
• Click start Calibration.<br />
restore Defaults<br />
This control will set your <strong>Cricut</strong> Imagine back to its factory settings,<br />
removing any calibration changes you have made previously.<br />
SETTInGS<br />
33