english

ENGLISH
44
5.2.2 EVERY MONTH
• Check the grease and wear state of the chains and the integrity of their fixage through the front side of each column after having taken the
platform to maximum height. If necessary, lubricate with grease and in case of wear replace with new versions of the same piece.
• Check that the hoist screw set is tightly sealed.
• Check hydraulic seal; tighten loosened connectors where necessary.
• Check that the hydraulic hoses are in good state. Replace damaged parts with original components when necessary.
• Check that the pivots, rollers, bushings, saddle-arms frame and their extensions are greased well and in good state; if necessary, replace the
damaged parts with original components.
5.2.3 EVERY 200 HOURS
• Replace oil in the hydraulic system, discharging the old one out of the pump and clean oil filter. Refer to the respective spare parts table enclosed
in this manual for this operation. A correct performance of these operations will totally come to the user's advantage. The equipment will
indeed be in perfect state when work is resumed.
5.3 EMERGENCY HYDRAULIC PUMP
By request it is possible to install an emergency hydraulic pump in case of electricity failures or (as described in paragraph 4.5 “Emergency lowering”)
to solve problems caused by occasional blockages in the lowering system.
Please remember that AGM-CO.SMET Srl or its distributors are always available if assistance or spare parts are needed.