G&D DVIMUX8-OSD-USB - Guntermann und Drunck GmbH

Startup
Startup
You can operate the KVM switch immediately after its installation.
How to turn on the KVM switch:
1. Turn on the Power switch on the back panel of the KVM switch.
System startup
After you turn on the KVM switch, the console monitor displays information about the
System Startup. In addition to the installed firmware, you are also informed if keyboard
and mouse are detected.
ADVICE: You can press Pause to pause the process. Press any other key to continue
the process.
If the KVM switch is ready for operation. the Select Computer or Login dialogue opens.
Status displays
The LEDs on the front panel of the KVM switch highlight the device‘s current operational
status:
Section LED Status Meaning
CPU 1 … 8 Active on The computer‘s KVM signals are transmitted to the console
of the KVM switch.
The computer can be operated at the console.
off The channel is currently inactive.
Status on The computer is ready for operation.
off No computer is connected or the computer is turned off.
User Active on The keyboard is initialised successfully.
7 · G&D DVIMUX8-OSD-USB
blinking The console keyboard cannot be found.
Status on The KVM switch is supplied with the necessary voltage.
off The KVM switch is turned off or is not supplied with the
necessary voltage.
If necessary, check the proper connection of the power
supply cable.