Sony XAV-W1 Car Radio OWNER'S MANUAL Operating Instructions ...

14
Getting Started
Resetting the unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Press the reset button with a pointed object, such
as a ball-point pen.
Reset button
Note
Pressing the reset button will erase the clock setting
and some stored contents.
Performing initial settings
SRC OFF
After resetting, the display for the initial speaker
settings appears.
Be sure to set correctly following the procedure
below to enjoy the various sound functions of
this unit.
To skip the initial settings, press (OFF)/(SRC),
or insert a disc.
Note
The initial setting display automatically disappears if
no operation is performed for 30 seconds.
During setup procedure, it is canceled if no operation
is performed for 15 seconds.
1 Set the center speaker connection
status.
Touch “ON” if a center speaker is connected,
or “OFF” if not.
2 Set the subwoofer connection status.
Touch “ON” if a subwoofer is connected, or
“OFF” if not.
3 Set the listening position.
Touch “Front L” if your listening position is
front left, or “Front R” if front right.
4 Touch “OK.”
The source list appears when the setting is
complete.
This setting can then be further configured in
setup.
For details on setting the speaker connection
status, see “Setting the speaker connection
status” on page 34. For details on setting the
listening position, see “Optimizing sound for the
listening position — Intelligent Time
Alignment” on page 33.
Note
If you set to “Center Speaker ON” without connecting
the center speaker, vocal sound is not output, and if
you set to “Subwoofer ON” without connecting the
subwoofer, bass sound is not output.
Preparing the card remote
commander
Before using the card remote commander for the
first time, remove the insulation film.