Betriebs- und Installationsanweisung Operating and Installation ...

Expansion level / Process time
Setting the process time
A process time can be specified for a cooking operation. After this time
expires, the cooking operation is ended automatically.
The target temperature can be changed both before and after the
process time has been set.
Selecting the process time
Press
briefly.
The target process time last set flashes in the LED display and can be
changed with the arrow buttons.
The LED display “Setting/displaying the process time” comes on.
If no further setting is made within 5 seconds, the target process time
is taken over. The cooking process now ends automatically on expiry
of the process time.
The remaining process time is shown in the LED display.
Changing the remaining process time
Press or briefly.
The LED display flashes the remaining process time.
Pressing
Pressing
prolongs the remaining process time.
shortens the remaining process time.
☞ If the or button is kept depressed, the time is initially set
in 1-minute increments.
After the first ten minutes the changes are made in 10-minute
increments.
If no further setting is made within 5 seconds, the changed remaining
process time is taken over and displayed again not flashing.
The end of the cooking time
The end of the process time is indicated by an acoustic signal and the
flashing of in the LED display.
The LED display “Appliance in use” goes off.
After about 20 seconds the acoustic signal stops, and the
actual pan temperature is displayed.
Briefly pressing starts the cooking process again with the
process time previously used.
Pressing for 3 seconds acknowledges the end of the cooking
process. The appliance heats up to the preset target
temperature.
FGS/UGS 07 25 17 Bl.25 25