catena cta1-v2/cta2-v2 / brick bra1-v2 / closed cla-v2 - Spectral

Using a universal remote control for a
SPECTRAL sound system
The main functions of the SPECTRAL sound system can also be controlled by
other universal remote controls.
The following functions can be controlled by IR signals:
• Power
• Mute
• Volume +/-
• mode
• input signal
• scroll key
• arrow keys
Please note:
The IR link system is required to use a universal remote control for a SPECTRAL
sound system.
Fix the IR transmitter at the back of the device with the fixing clip (please refer to
picture „Rear view...“, page 37/38).
Learning IR commands:
Start the „Learn Menu“ by pressing and at the same time, select
„IR Learn“ and take the last position „sound system“.
Confirm you selection by pressing . Press „exit“ to leave the menu.
Use to select the sound system. Now you can assign the single functions
of your SPECTRAL sound sytem to another universal remote control.
55
4.1 and 5.1 mode
The Pre (2.1/5.1 Mode) output enables the connection of active wireless
loudspeakers, for example.
Depending on the selected setting in the system menu (Factory Set/system preset),
the front channels are put out in the 2.1 mode or the surround loudspeakers in
the 4.1/5.1 mode.
Connecting additional loudspeakers you can use the SPECTRAL sound system
also in 4.1 or 5.1 mode:
BRA1, CLA1, CTA1, CTA2: Connecting additional active loudspeakers for
rear right and left enables 4.1 mode.
Option: additional active subwoofer
CLA1, CTA2: Connecting additional active loudspeakers for rear
right and left and an additional passive center
speaker enables 5.1 mode.
Option: additional active subwoofer
If additional speakers are connected you have to select the corresponding mode
in the system menu (factory set => system preset).
The sound parameters of these speakers are adjustable in the speaker setup (level
trim, speaker distance and room comp).
Deutsch
English