DIGITAL RESEARCH(r) CP/M Plus TM (CP/M Version 3) Operating ...

CP/M 3 Messages CP/M 3 User's Guide
Table A-1. (continued)
Message Meaning
Break "x" at c
ED. "x" is one of the symbols described below and c is the
command letter being executed when the error occurred.
# Search failure. ED cannot find the string specified in an
F, N, or S command.
? Unrecognized command letter c. ED does not recogn ize
the indicated command letter, or an E, Hi 0, or Q command
is not alone on its command line.
0 The file specified in an R command cannot be found.
> Buffer full. ED cannot put any more characters in the
memory buffer, or the string specified in an F, N, or S
command is too long.
E Command aborted. A keystroke at the console aborted
command execution.
F Disk or directory full. This error is followed by either
the disk or directory full message. Refer to the recovery
procedures listed under these messages.
CANNOT CLOSE:
Cannot close f i le
CANNOT CLOSE FILE.
CANNOT CLOSE DESTINATION FILE - filespec
Cannot delete file ,
GENCOM, HEXCOM, LIB-80tm. LINK-80, MAC, PIP, RMAC,
SUBMIT. An output file cannot be closed. This can occur if the
disk is removed before the program terminates.
GENCOM. CP/M cannot delete a file. Check to see if the COM
file is Read-Only or password-protected.
A-3