1747-6.5.5, SL 500 DeviceNet Scanner Module User Manual
1747-6.5.5, SL 500 DeviceNet Scanner Module User Manual
1747-6.5.5, SL 500 DeviceNet Scanner Module User Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Configuring the Ethernet<br />
Communications Channel<br />
Configuring <strong>SL</strong>C 5/05 Ethernet<br />
Communications<br />
Appendix E<br />
Before you can communicate with the <strong>SL</strong>C 5/05 processor over an<br />
Ethernet network, you must configure the processor’s Ethernet<br />
communications channel (Channel 1).<br />
• If you are also interfacing your processor to a ControlNet<br />
network via a <strong>1747</strong>-KFC15 module, you can configure the<br />
communications via the ControlNet network. See chapter 6 for<br />
information on going online to the processor over a ControlNet<br />
network.<br />
• If you are not interfacing your processor to a ControlNet<br />
network you can configure the communications via the<br />
processor’s RS-232 port (channel 0) using a DF1 driver (see<br />
Appendix F).<br />
The following procedure describes how to configure the Ethernet<br />
channel using R<strong>SL</strong>ogix <strong>500</strong> software:<br />
1. Start R<strong>SL</strong>ogix <strong>500</strong> and go Online with your <strong>SL</strong>C <strong>500</strong> processor,<br />
using either your ControlNet driver or your DF1 driver.<br />
2. In the Project window, double-click on Channel Configuration<br />
under the Controller folder.<br />
1 Publication <strong>1747</strong>-<strong>6.5.5</strong> - August 2000
Change language