1747-6.5.5, SL 500 DeviceNet Scanner Module User Manual
1747-6.5.5, SL 500 DeviceNet Scanner Module User Manual
1747-6.5.5, SL 500 DeviceNet Scanner Module User Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
IMPORTANT<br />
Creating and Running the Example Application Program 6-5<br />
You must also place the <strong>1747</strong>-SDN scanner in run<br />
mode by setting the Run Bit (bit 0) in the scanner’s<br />
command register. The command register is located<br />
at word 0 in the Output image table.<br />
6. Double-click on the O0 - OUTPUT file under the Data Files folder.<br />
You will see the <strong>1747</strong>-SDN module’s command register (file O:2.0<br />
below).<br />
7. Set bit 0 in the command register to "1", as shown above.<br />
8. Press and release the START button on the RediSTATION. The red<br />
light should turn on. On your screen, you will see rung 1 in your<br />
ladder program being energized as you press the button.<br />
9. Pass your hand back and forth over the photoeye several times. On<br />
your screen you should see the counter increment.<br />
10.Press and release the STOP button on the RediSTATION. The red<br />
light should turn off. On your screen, you will see rung 2 in your<br />
ladder program being energized as you press the button.<br />
This completes the ControlNet example.<br />
Publication <strong>1747</strong>-<strong>6.5.5</strong> - August 2000
Change language