PhD Thesis Arne Lüker final version V4 - Cranfield University

More documents

Recommendations

Info

108 Lead Strontium Titanate (PST) 6. Y. Somiya, A.S. Bhalla, and L.E. Cross, “Study of (Pb,Sr)TiO3 ceramics on dielectric and physical properties”, Int. J. Inorg. Mater., 3 (2001) 706 – 714 7. F. Du and L. Shi, “Solvothermal growth of single-crystal hexagonal prismatic SrCO3 microrods”, Cryst. Res. Technol. 42, No. 3, 216 – 220 (2997) 8. S. Li, H. Zhang, J. Xu, and D. Yang, „Hydrothermal synthesis of flower-like SrCO3 nanostructures”, Materials Letters 59 (2005) 420 – 422 9. G.S. Guo, F.B. Gu, Z.H. Wang, and H.Y. Guo, “Low-temperature Growth of Single-crystal SrCO3 Nanoneedles” Chinese Chemical Letters 16, No. 8, 1101 – 1104 (2005) 10. T. Riekkinen, T. Mattila, S. van Dijken, A. <strong>Lüker</strong>, Q. Zhang, P.B. Kirby, A.M. Sánchez; “Ferroelectric parallel-plate capacitors with copper electrodes for high- frequency applications”, Appl. Phys. Lett. 91, 252902, 2007 11. W. Fan, S. Saha, J.A. Carlisle, O. Auciello, R.P.H Chang, R. Ramesh; Layered Cu-based electrode for high-dielectric constant oxide thin film-based devices; Appl. Phys. Lett. 82, 9 (2003) 1452 12. W. Fan, B. Kabius, J.M. Hiller, S. Saha, J.A. Carlisle, O. Auciello, R.P.H. Chang, R. Ramash; Materials science and integration bases for fabrication of (BaxSr1- x)TiO3 thin film capacitors with layered Cu-based electrodes; J. Appl. Phys. 94, 9 (2003) 6192 13. D.C. Dube, J. Baborowski, P. Muralt, and N. Setter; The effect of bottom electrode on the performance of thin film based capacitors in the gigahertz region; Appl. Phys. Lett. 74, 3546 (1999) 14. T.R. Taylor, P.J. Hansen, B. Acikel et al., Appl. Phys. Lett. 80, 1978 (2002) 15. P Bao, T J Jackson and M J Lancaster, Dielectric characterization of a ferroelectric film in the sub-GHz region, J. Phys. D: Appl. Phys. 41 (2008) 185410
Sol-Gel derived Ferroelectric Thin Films for Voltage Tunable Applications There are no physicists in the hottest parts of hell, because the existence of a 'hottest part' implies a temperature difference, and any marginally competent physicist would immediately use this to run a heat engine and make some other part of hell comfortably cool. This is obviously impossible. Richard Davisson That theory is worthless. It isn't even wrong! Wolfgang Pauli Science is facts; just as houses are made of stones, so is science made of facts; but a pile of stones is not a house and a collection of facts is not necessarily science. Henri Poincare (1854 - 1912) 109
Page 1 and 2:
Sol-Gel derived Ferroelectric Thin
Page 3 and 4:
Abstract Ferroelectric perovskite t
Page 5 and 6:
Acknowledgements I want to take thi
Page 7 and 8:
Table of Content Introduction and M
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60: Sol-Gel derived Ferroelectric Thin
Page 99 and 100: Intensity [arb. Units] (g) (f) (e)
Page 103 and 104: Relative diel. diel. constant Const
Page 109: Sol-Gel derived Ferroelectric Thin
Page 113 and 114: Intensity [arb. Units] Intensity [a
Page 121 and 122: Tunability [%] 100 90 80 70 60 50 4
Page 131 and 132: (g) (f) (e) (d) (c) (b) (a) Sol-Gel
Page 149 and 150: Intensity [arb. Units] Sol-Gel deri
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Internships: Sol-Gel derived Ferroe
show all

PhD Thesis Arne Lüker final version V4 - Cranfield University

Create successful ePaper yourself

Delete template?

Save as template?