WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Dismantling the Dynamo<br />
Please note:<br />
When repairing the dynamo, remove the engine. Proceed as<br />
explained on page 9, "Dismantling the engine, Reassembling the<br />
engine", paragraphs 1 to 13.<br />
1. Undo hex. screw (SW 17) <strong>for</strong> bracket clamp (right-hand side)<br />
and remove clamp.<br />
2. Take off the contact breaker cover plate. (Watch out <strong>for</strong> the<br />
gasket, as this can be used again). Undo the two slot-headed<br />
screws; take off the contact breaker plate.<br />
3. Using socket spanner (SW 10), screw off nuts 33/1, 33/3 and the<br />
three nuts 33/2 (SW 14), remove fan housing.<br />
4. Apply the retaining arm of the jig (401/W 9) to the fan wheel<br />
and lock the latter. Take off the four cheese-head screws 34/2,<br />
remove cover plate and fan wheel.<br />
5. Screw off two fillister-head screws 35/1 and remove the centrifugal<br />
governor<br />
Please note:<br />
To change the contact breaker cam, remove the disc. Lift off<br />
spacer and Novotex (plastic) disc and take off cam.<br />
6. Apply the retaining arm of jig (401/W 9) 341 or jig (407/W 21)<br />
2/10 (using the two bores on the armature) and undo screw<br />
(SW 17) 39/3.<br />
Remove disc and spring washer.<br />
33 Removing the fan hous ng<br />
34 Locking the fan wheel<br />
3 5 Centrifugal governor