WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3. Tighten counter nut on setting screw.<br />
Please note:<br />
When setting screw cannot be further adjusted, screw in setting<br />
screw 77/5 fully into clutch cover. Loosen hex. nut 77/7 on clutch<br />
lever. Turn clutch pin 77/8 to the left and again tighten hex. nut<br />
77/7.<br />
Carry out final adjusting on setting screw on clutch cover.<br />
Adjusting the Headlamp<br />
Please note:<br />
The headlamp should be adjusted be<strong>for</strong>e a bright workshop<br />
wall, upon a level surface, the vehicle has to be under load at<br />
the following tyre pressures:<br />
Driver only<br />
Driver with<br />
pillion passenger<br />
Driver with<br />
sidecar passenger<br />
Driver with<br />
pillion and<br />
sidecar passengers<br />
1. Place vehicle at 10 m distance from wall to middle of frontwheel.<br />
2. Mark a cross on the wall at 640 mm from foot of wall (=distance<br />
from floor to centre of headlamp).<br />
3. Switch on the "far" beam. If the headlamp is correctly adjusted,<br />
the beam centre must coincide with the middle of the cross.<br />
4. Switch on dip light. The separating line between lower brighter<br />
and upper darker beam sections should lie at 10 cm below the<br />
cross centre.<br />
5. If headlamp setting is to be adjusted, loosen the countersunk<br />
fillister-head screws on the support ring of the headlamp.<br />
6. Adjust headlamp and check again as explained in paragraphs<br />
3 and 4. Tighten the countersunk screws again.<br />
0,64 m<br />
78 Adjusting the headlamp<br />
Front Rear Sidecar<br />
wheel wheel wheel<br />
18 psi 26 psi<br />
18 psi 29 psi<br />
22 psi 29 psi 22 psi<br />
22 psi 36 psi 29 psi