WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Fitting the Swinging Arm<br />
1. Into the groove in the rear swinging arm mounting on the<br />
engine housing fit the rubber sealing ring with grease.<br />
2. Lay on rear collar bearing 53/4 with ball bearing 6303 and<br />
radial gasket 25x35x7.<br />
I<br />
Please note:<br />
Packing lug of radial gasket 52/1 must face in the direction of<br />
ball bearing 6303, see Fig. 52.<br />
3. I nsert plate spring into driven shaft 53/5.<br />
4. Place gasket in position on collar bearing 53 4 (<strong>for</strong> better<br />
adhesion, use grease).<br />
5. Insert Seeger ring on swinging arm (on rear hub side), press in<br />
balll bearing 6304, and secure by means of Seeger ring. Press in<br />
radial gasket (oil seal) 30x52x10.<br />
6. Tap the rear axle back (on the brake disc side).<br />
7. Fit Collar bearing on chain wheel side over rear axle as rar<br />
as ball bearing.<br />
8. Fit ball bearing 6304.<br />
9. Fit chain into swinging arm. (Watch <strong>for</strong> appropriate running<br />
direction of and colour markings on chain!)<br />
1 0. Fit large chain wheel, fit chain.<br />
11. Place chain wheel with chain mounted onto the toothed portion<br />
of rear wheel axle.<br />
12. Screw on crown nut54/7. Tap the rear axle back in the direction<br />
of the brake disc as far as the shoulder of the chain wheel.<br />
13. Fit small chain wheel in the swinging arm fitted with the large<br />
chain wheel and the chain.<br />
1 4. Place the whole swinging arm on rear collar bearing 53/4 and<br />
place small chain wheel on driven shaft.<br />
1 5. Fix nut 54/5 (SW 10) in position between swinging arm and<br />
crankcase. Put sealing compound on gasket and nut.<br />
16. Lock fan wheel by means of retaining jig (401/W 9); Put in gear.<br />
52 Radial Gasket <strong>for</strong> drivel shaft<br />
53 Swinging arm mounting, rear collar bearing<br />
54 Fitting swinging arm