WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...

Please note:
ADJUSTING the HEADLAMP on MODEL 103 A-2
The headlamp is to be checked or adjusted before a bright wall and only with 2 persons up or 70 kg
load on each seat with the correct tyre pressure (front 14 psi, rear 28 psi). The vehicle has to be
placed upon a level surface. Proceed likewise with a scooter with sidecar, sidecar without load.
Adjusting the headlamp
1.) Place vehicle at a distance of 10 m from wall to centre of front-wheel.
2.) Mark a cross on the wall at 0. 65 m from foot of wall (= distance from floor to centre
of headlamp).
3.) Switch on the "far" beam. If the headlamp is correctly adjusted, the beam centre must
coincide with the middle of the cross.
4.) Switch on dip light. The separating line between lower brighter and upper darker beam
sections should lie at least 10 cm below the cross centre.
5.) Right-hand setting screw serves for vertical, left-hand one for horizontal adjustment.
6
Page 47
i' I
3.
4.
5.
5.
C
1
2
3
4
5