WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...

Removing and Fitting of Frame
Please note:
After carrying out the following operations, the frame can be
removed. The following sequence is only suggested:
1. Remove the engine (see page 9, paragraphs 1 to 4 and 7 to 13).
2. Remove the battery-holder.
3. Take off the foot board with rubber journals.
4. Remove front fork (see page 43, paragraphs 1 to 5 and 7 to 13).
5. Remove the front shield with starting unit, fuse box and brake
li ght switch.
6. Remove horn.
7. Remove engine suspension and ignition coil.
8. Take off foot brake lever with control cable.
9. Remove centre prop stand.
1 0. Withdraw steering lock.
11. Take out frame ball races (page 44, paragraph 1).
12. Check frame.
13. For reassembly, reverse above procedure.
Please note:
Crash-damaged frames can be checked at the HEINKEL factory
by means of a special jig. Slightly bent frames (i.e. when the
frame tube has not been flattened and thus correct stability is
still ensured) can be straightened out. When fitting the control
cables 79/1 and electric leads, these have to be placed on both
sides of the frame as shown in figure 79, and secured with cable
strings 72/2.
79 Leads and Cables