WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Fitting Crankshaft and bearing<br />
1. Fit Seeger ring 63/1, using special pair of <strong>for</strong>ceps 63/2, into lefthand<br />
crankcase housing (clutch side).<br />
2. Heat left-hand housing half on a hot plate (do not use a weldi<br />
ng torch or any naked flame) to about 80 ° -90 ° C.<br />
3. Fit ball bearing 6305 C 3. (Take care not to damage race seat in<br />
housing.)<br />
4. Secure ball bearing with Seeger ring.<br />
5. Lay the right-hand crank disc (dynamo side) on the U-shaped<br />
plate (recess <strong>for</strong> the big end) and press in ball bearing 6305 C3.<br />
Original <strong>HEINKEL</strong> Exchange Crankshafts are supplied with bearings<br />
already in pressed-in position.<br />
6. Heat half of crankcase housing (dynamo side!) on a hot-plate<br />
to about 175/195 ° F.<br />
(Do not use welding torch or any naked flame.)<br />
7.<br />
Using a fitting prod, punch in the radial sealing ring from the<br />
dynamo side.<br />
8. Fix the heated crankcase half on the flange of the assembly jig,<br />
resting it on the support 24/1.<br />
9. On the inside of the crankcase half, above the bore <strong>for</strong> the<br />
bearing, insert a metal strip 651 (1.80x25x0.3 mm).<br />
1 0. Fit crankshaft 65/1.<br />
63 Fitting the Seeger rings<br />
64 Assembly iig with crankcase hal!<br />
65 Fitting the crankshaft