WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
WORKSHOP MANUAL for HEINKEL TOURIST - Secret Society ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Dismantling The Swinging Arm<br />
Please note:<br />
For repairs to the swinging arm, please proceed as explained<br />
under "Dismantling the Dynamo", page 23, paragraphs 1, 2, 3.<br />
1. Remove 6 hex. nuts (SW 10) with discs, take off swinging arm<br />
cover. Remove gasket.<br />
2. Remove rubber protecting cap on brake disc. Take off clips on<br />
both sides of rear axle.<br />
3. Insert retainer arm of jig (407/W 37) 275 into bore on swinging<br />
arm (fixing <strong>for</strong> spring leg). Lock retainer arm claw on bolt of<br />
brake disc; using socket spanner (SW24),undo both crown nuts<br />
and remove brake disc.<br />
4. Using socket spanner (SW 10), undo 2 hex. screws 48/2 and nut<br />
48/3. Remove outer collar bearing.<br />
5. Remove retaining plate <strong>for</strong> nut 49/4 on small chain wheel.<br />
6. Using socket spanner (SW 19), undo nut 49/4 (left-hand thread!).<br />
7. Apply the extractor tool (401 1 W22) 50/1, use the <strong>for</strong>ked spanner<br />
(SW32)50/2 as a counter holder, and withdraw the chain wheel.<br />
8. Using <strong>for</strong>ked spanner (SW 10), undo the nut 50%5 between the<br />
swinging arm mounting and the crank-housing whilst the swinging<br />
arm is simultaneously taken off.<br />
9. Remove swinging arm, take off small chain wheel.<br />
48 Swinging arm mounting<br />
49<br />
Small chain wheel with retaining<br />
plate and nut<br />
50 Removing the chain wheel