[10] TEST COMMAND, TROUBLE CODES - OlsonBros

Main Sub
code code
48 01 Main scan/sub scan
direction magnification ratio
(COPY MAG.)
Contents Details of function/operation
05 SPF/RSPF mode sub scan
direction magnification ratio
in copying (SPF/RSPF
MAG.) (Disabled when set to
OC)
[Function]
Used to adjust the magnification ratio in the main scan (front/rear) direction and sub scan direction.
Enter the adjustment value with [10KEY]. Press [START] key to save the set value and make a copy.
(When the adjustment value is increased by 1, the magnification ratio is increased by 0.1%.)
The adjustment mode can be changed by pressing [←/→] key. (Adjustment range: 1 – 99, Default: 50)
Mode Display item Default value LED
Main scan direction magnification ratio F-R 50 PRINT mode lamp
OC mode sub scan direction
magnification ratio
SCAN 50 SCAN mode lamp
[Operation]
The operation is similar to test command 46-01.
[Function]
Used to display the current SPF/RSPF mode sub scan direction magnification ratio on the LCD.
When [START] key is pressed, the entered data is acquired and saved into the EEPROM, and a copy
is made. (When the set value is increased by 1, the magnification ratio is increased by 0.1%.)
(Adjustment range: 1 – 99, Default: 50)
When adjusting the RSPF, use [2-SIDED COPY] key to select single/duplex after entering the one
page print mode, performing 2-page single copy.
For printing, regardless of the density mode and the density level,
Density mode = MANUAL
Density level = 3
Mode Display item Default LED
Sub scan magnification ratio adjustment on the
surface of SPF/RSPF document
SIDE1 50 COPY mode lamp
Sub scan magnification ratio adjustment on the
surface of RSPF document *1
SIDE2 50 PRINT mode lamp
∗ When there is no document in SPF, copy is inhibited.
*1: Only when RSPF is installed. If installed, skipped.
[Operation]
The operation is similar to test command 46-01.
AR-168S/168D TEST COMMAND, TROUBLE CODES 10 - 24