[10] TEST COMMAND, TROUBLE CODES - OlsonBros

Main Sub
code code
66 32 Receive data check
(Executable only when the
FAX is installed.)
Contents Details of function/operation
33 Signal detection check
(Executable only when the
FAX is installed.)
34 Communication time
measurement (Executable
only when the FAX is
installed.)
37 Speaker sound volume
setting (Executable only
when the FAX is installed.)
[Function]
Use to check the receive data.
[Operation]
1) Initial display 2) After completion of reception
RECEIVING RESULT
[Function]
Use to check the signal detection.
[Operation]
1) Initial display
CHECKING NONE
PRESS CLEAR TO STOP
[Function]
Use to measurement the communication time.
[Operation]
[Function]
Use to set the speaker sound volume.
1: NO SOUND
2: LOW
3: MID
4: HIGH
[Operation]
AR-168S/168D TEST COMMAND, TROUBLE CODES 10 - 37
xx
"xx" is "OK" or "NG" depending on the check
result.
∗ [CLEAR] key: FAX control is terminated.
When a signal is detected, the display is changed from NONE to the following.
CI/CNG/CED/BT/DT/Flag/SDT/DTMF
∗ [CLEAR] key: FAX control is terminated.
1) Initial display
COMM. TIME
xx:xx:xx:xxx msec
"xx:xx:xx:xxx" indicates o'clock, minute, second, millisecond.
∗ [CLEAR] key: FAX control is terminated.
1) Initial display
SELECT SPEEKER VOL.
PRESS ←, →
2) [←/→] or after 2sec
Every time when [→] key is pressed, the second line is changed in the sequence of 1 → 2 → 3 →
4 → 1.
When [←] key is pressed, the sequence is reversed.
SELECT (1-4)
1:NO SOUND
∗ [CLEAR] key: FAX control is terminated.
3) [ENTER] key
STORED
xxx
xxx: Set content
After 2sec, FAX control is terminated.
SELECT (1-4)
2:LOW
.....