User's Manual ND 281, NDP 281 - heidenhain - DR. JOHANNES ...

More documents

Recommendations

Info

Finding Minimum and Maximum Values 10 Starting a series of measurements repeatedly MOD MAX repeatedly MOD START Select the display for a series of measurements. The selected indicator blinks (here, MAX). Confirm selection. ... until the indicator START blinks. Start the series of measurements. Indicator preselection Press MOD to start the series of measurements and select the display with the indicators. Operating parameter P86 allows you to define which indicator is displayed first when MOD is pressed. Switching between MIN, MAX, DIFF and ACTL displays It is not possible to switch between the displays as described below if the switching input for external control of the series of measurements (pin 6 on D-sub connection EXT) is active. As an alternative, you can select the display with operating parameter P21 (see “Operating Parameters”). repeatedly MOD MIN Select the new display of a series of measurements. The selected indicator blinks (here, MIN). Confirm the change. The display now shows the smallest value measured during the current series of measurements.
Starting a new series of measurements repeatedly MOD START Select the indicator START. The indicator START blinks. Ending a series of measurements repeatedly MOD Start a new series of measurements. Select the active indicator (MIN, ACTL, MAX, DIFF). The indicator that lit up last blinks. End the series of measurements. Finding Minimum and Maximum Values 11
Page 1 and 2: User's Manual ND 281 NDP 281 Measur
Page 3 and 4: Key Function Set datum Transfer inp
Page 5 and 6: Contents Working with the ND Displa
Page 7 and 8: Switch-On, Crossing Over the Refere
Page 9: Finding Minimum and Maximum Values
Page 13 and 14: Measured Value Output For technical
Page 15 and 16: Error Messages Display Problem Last
Page 17 and 18: Rear Panel Connections X1, X31 and
Page 19 and 20: Power Connection Electric shock dan
Page 21 and 22: Code number for changing protected
Page 23 and 24: Parameter Settings / Function Linea
Page 25 and 26: Linear Encoders The ND 281 and NDP
Page 27 and 28: Parameter settings for HEIDNHAIN li
Page 29 and 30: Parameter settings for HEIDENHAIN l
Page 31 and 32: Pin layout RS-232-C/V.24 (X31) Pin
Page 33 and 34: Measured value output after signal
Page 35 and 36: Switching Inputs and Outputs EXT (X
Page 37 and 38: Setting and zero resetting the disp
Page 39 and 40: Switching signal for errors The dis
Page 41 and 42: Specifications Housing ND 281 Bench
Page 43 and 44: NDP 281: Dimensions in mm/inches 11

User's Manual ND 281, NDP 281 - heidenhain - DR. JOHANNES ...

Create successful ePaper yourself

Delete template?

Save as template?