User's Manual ND 281, NDP 281 - heidenhain - DR. JOHANNES ...

Switching Inputs EXT (X41)
38
Switching signals
As soon as the trigger points defined in parameters are
reached, the corresponding outputs (pins 15,16) are activated.
You can set up to two trigger points. The switching point
“zero” has a separate output (see “Zero crossover”).
Signals for sorting and tolerance checking
If the sorting limits defined in parameters are exceeded, the
corresponding outputs (pins 17, 18) are activated.
Signals Operating parameters Pin
Switching signals P62, switching limit 1
15 P63, switching limit 2
16
Sorting signals P18, lower sorting limit 17
P19, upper sorting limit 18
Zero crossover
The display value “zero” activates the corresponding output
(pin 14). Minimum signal duration is 180 ms.
Weg Path
5
Pin 15
(A1)
Output
Switching point
Measured value < Lower sorting limit
Measured value > Upper
sorting limit
Lower limit Upper limit
t dv
t dv
Path
Path
Time curve of a signal at pin 15 for trigger limit (A1) = 5 mm , t d≤ 22 ms
t
t