User's Manual ND 281, NDP 281 - heidenhain - DR. JOHANNES ...

More documents

Recommendations

Info

Mounting 18 Mounting M4 screws are required for securing the ND 281 display unit from below (see illustration at right). The NDP 281 display unit is designed for panel mounting (see “Dimensions” for the mounting dimensions). ND 281 display units are stackable. Adhesive plug-in feet (supplied with your unit) prevent the stacked units from being moved out of place. 172 ± 0.2 6.77 ± .008" Hole positions for mounting the ND display unit 15° Alternatives of stacking the display units 140 ± 0.2 5.51 ± .008"
Power Connection Electric shock danger Unplug the power cord before opening the housing. Connect the grounding conductor. Do not interrupt the grounding conductor. Potential component damage Do not engage or disengage any connections unless the power is off. Only use original type fuses. To increase the noise immunity, it is recommended that you attach the ground terminal to, for example, the central ground point of the machine. (Minimum cross section 6 mm 2.) Line voltage range: 100 Vac to 240 Vac A voltage selector is therefore not necessary. Minimum cross section of the power cord: 0.75 mm 2 ND 281 The rear panel of this unit contains a connecting jack for a power cord with Euro connector (power cord supplied with the delivery). NDP 281 The rear panel of this unit features a terminal (X51) for power connection (see illustration to the right). Be careful to wire the connecting cable with the correct polarity. X51 X 51 L1 N NDP 281: Terminal for connecting the power cord Power Connection 19
Page 1 and 2: User's Manual ND 281 NDP 281 Measur
Page 3 and 4: Key Function Set datum Transfer inp
Page 5 and 6: Contents Working with the ND Displa
Page 7 and 8: Switch-On, Crossing Over the Refere
Page 9 and 10: Finding Minimum and Maximum Values
Page 11 and 12: Starting a new series of measuremen
Page 13 and 14: Measured Value Output For technical
Page 15 and 16: Error Messages Display Problem Last
Page 17: Rear Panel Connections X1, X31 and
Page 21 and 22: Code number for changing protected
Page 23 and 24: Parameter Settings / Function Linea
Page 25 and 26: Linear Encoders The ND 281 and NDP
Page 27 and 28: Parameter settings for HEIDNHAIN li
Page 29 and 30: Parameter settings for HEIDENHAIN l
Page 31 and 32: Pin layout RS-232-C/V.24 (X31) Pin
Page 33 and 34: Measured value output after signal
Page 35 and 36: Switching Inputs and Outputs EXT (X
Page 37 and 38: Setting and zero resetting the disp
Page 39 and 40: Switching signal for errors The dis
Page 41 and 42: Specifications Housing ND 281 Bench
Page 43 and 44: NDP 281: Dimensions in mm/inches 11

User's Manual ND 281, NDP 281 - heidenhain - DR. JOHANNES ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?