ER-200D Personal Noise Dosimeter with Data Logging User Manual

More documents

Recommendations

Info

Data Screen Downloading Stored Data · From either the Home screen or Setup screen, click “Data” on the menu bar. · Click “Read ER-200D Data.” The blue status bar indicates “Reading ER-200D data” 46
Data Table All data runs are displayed in the Data Table, with the most recent run at the top of the list. · Serial Number: Device serial number · Run: Sequential, beginning with 001 · Run Type: Normal or QuickCheck · Final Dose %: Dose at end of run · Overall Leq: A-weighted continuous equivalent sound level · Run Description: This is a textbox in which the user can enter data describing the run ExAMPLE: “Jane Smith, Packing Line 1, Full Capacity, First Shift, 5-18-2009.” To Enter A Run Description · Double-click on the desired run or click the blue “Describe Run” box on the screen. · Type information into dialogue box and click OK. · Run description will be immediately updated. Note: Once a report is created, the Run Description cannot be altered in the report. A new report can be made, but it must be saved using a different file name. · Run Length: Actual run time, displayed as Days-Hours-Minutes-Seconds · Max Run Length: Maximum time the dosimeter could run · Exchange Rate, Criterion and Threshold: As selected from the Setup Screen · Signal Source: internal microphone (default) or direct input · Calibration: Calibration value used at the time of the run · Run Termination: Completed normally; manual shutdown; or sudden power loss · Warnings: Any warnings that occurred during the run · Software Version: software version at the time of the run 47
Page 1 and 2: Personal Noise Dosimeter 1 User Man
Page 3 and 4: Introduction Hearing loss from loud
Page 5 and 6: Identification of Parts A Microphon
Page 7 and 8: Windscreen Windscreen fits on top o
Page 9 and 10: Status Check Power ON · Press and
Page 11 and 12: Interpreting Results Normal Mode (B
Page 13 and 14: Interpreting Results QuickCheck Mod
Page 15 and 16: What Dose % Means Noise dose is a m
Page 17 and 18: Data Logging Normal and QuickCheck
Page 19 and 20: Specifications The default settings
Page 21 and 22: Risk Factors for Hearing Loss Healt
Page 23 and 24: About the Utility Suite The ER-200D
Page 25 and 26: Accept all licensing agreements. Cl
Page 27 and 28: Connect the USB cable to the ER-200
Page 29 and 30: Select “Install the software auto
Page 31 and 32: Utility Suite Screens Open the ER-2
Page 33 and 34: · Describe Highlighted Run: Opens
Page 35 and 36: The Setup Screen displays the facto
Page 37 and 38: Allow Previous Results to Be Overwr
Page 39: Restore Default Settings · · ·
Page 43 and 44: QuickCheck Runs · · QuickCheck ru
Page 45 and 46: Saving Data Reports are created and
Page 47 and 48: Excel Reports and Data Files The de
Page 49 and 50: Important Points (in alphabetical o
Page 52: 61 Martin Lane • Elk Grove Villag

ER-200D Personal Noise Dosimeter with Data Logging User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?