ER-200D Personal Noise Dosimeter with Data Logging User Manual

More documents

Recommendations

Info

Tab 2: Data Shows dose and Leq values for each 3.75 minute time block. These data can be used to create graphs in Excel if desired. Data are recorded as fractions of an hour, e.g., the data at 3.75 minutes is written as 0.062 (3.75 minutes ÷ 60 minutes = 0.062). Tab 3: Raw Data Ignore this tab. Data are used by the PC Interface Program for calculations. 54
Important Points (in alphabetical order) Disconnect without saving (p.51) · If user reads and displays data and then disconnects - Data are not saved. - Data will disappear from the Data screen but are still in the dosimeter. Displaying and printing results (pp. 46-52) · Normal Runs: The Utility Suite displays and prints real-time data. · QuickCheck Runs: The Utility Suite displays either real-time data or predictive data. - User can select length of exposure time for predictive data to view the corresponding dose %. - Only the default (1-Hr) predicted dose per hour is shown on the printed report. Initializing new dosimeters (p. 32) · Initialization is necessary the first time a dosimeter is used with a specific PC. · Once a dosimeter is initialized, the software will always recognize it by serial number. Measurement Window (p. 12) · In Normal mode, dose values are obtained every 220 msec, summed over a 3.75 minute interval and saved in nonvolatile memory every 3.75 minutes (16 times per hour). Overwriting Data (p.43) · When memory is full, data will be written over the oldest saved data unless “Allow previous results to be overwritten” is unchecked in the setup screen. · Download or remove data if you want to clear the memory for additional runs. Reading Data (p. 46) · Each time a dosimeter is connected its data must first be READ to be displayed.
Page 1 and 2: Personal Noise Dosimeter 1 User Man
Page 3 and 4: Introduction Hearing loss from loud
Page 5 and 6: Identification of Parts A Microphon
Page 7 and 8: Windscreen Windscreen fits on top o
Page 9 and 10: Status Check Power ON · Press and
Page 11 and 12: Interpreting Results Normal Mode (B
Page 13 and 14: Interpreting Results QuickCheck Mod
Page 15 and 16: What Dose % Means Noise dose is a m
Page 17 and 18: Data Logging Normal and QuickCheck
Page 19 and 20: Specifications The default settings
Page 21 and 22: Risk Factors for Hearing Loss Healt
Page 23 and 24: About the Utility Suite The ER-200D
Page 25 and 26: Accept all licensing agreements. Cl
Page 27 and 28: Connect the USB cable to the ER-200
Page 29 and 30: Select “Install the software auto
Page 31 and 32: Utility Suite Screens Open the ER-2
Page 33 and 34: · Describe Highlighted Run: Opens
Page 35 and 36: The Setup Screen displays the facto
Page 37 and 38: Allow Previous Results to Be Overwr
Page 39 and 40: Restore Default Settings · · ·
Page 41 and 42: Data Table All data runs are displa
Page 43 and 44: QuickCheck Runs · · QuickCheck ru
Page 45 and 46: Saving Data Reports are created and
Page 47: Excel Reports and Data Files The de
Page 52: 61 Martin Lane • Elk Grove Villag

ER-200D Personal Noise Dosimeter with Data Logging User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?