REFERENCE MANUAL E8-V5 - SIC-Venim s.r.o.

Subsequently, in the parameter edit mode, you will need to enter the diameter of the part present in the chuck (this
parameter will be requested on the general marking parameters entry screen), so that marking can be performed
accordingly. If the D axis option is present in the system, but you want to carry out plane marking, enter the value
‘zero’ for the diameter of the workpiece.
For normal use of the D axis, it must be mounted to the left of the marking head and the axis of the part must be
aligned exactly with the X movement head.
RATIO : Transmission ratio
V MIN, V MAX, V ORG : : Axis rate of movement
ACCEL. : Acceleration ratio
OFFSET Y : Maximum time of actuator movement
SENSOR : Type of sensor: Normal, Complemented or no sensor at origin.
RETURN TO ORIGIN : (YES or NO) generates return to origin at in cycle.
Accessory
Feeder
V MIN
V ORG
D axis
RATIO
V MIN
V MAX
V ORG
ACCEL.
OFFSET Y
SENSOR
PRIORITE
RETURN TO ORIGIN
Feeder
Marking position
Evac. position
RATIO
MASKED TIME RETURN
Part detection sensor
Clamping on output
V MAX
ACCEL.
Marking position : Feeder feed position for marking
Evac. position : If this position differs from the marking position, the loader will move to this
position at the end of marking.
RATIO : Transmission ratio
V MIN, V MAX, V ORG : : Axis rate of movement
ACCEL. : Acceleration ratio
MASKED TIME RETURN : Loader return to origin position during marking cycle
(Incompatible if the evacuation position is not the same as the marking position)
Part detection sensor : Detects workpiece input number (if present)
Clamping on output : Output number managing plate clamping (if present)
NOTREFE8V5US – R01 24/51